Industrial

18 Jan, 21

Is this job repetitive? (How 0-30% of the day might still be “repetitive”, or 67% may not be)

We are often asked to help employers accommodate workers with restrictions against “repetitive” work, or “repetitive” shoulder, back, or wrist demands. What is “repetitive”? Health & Safety Ontario’s relatively new Physical Demands Analysis Form uses these criteria for “frequency”: N=Not required R=Rarely (<2%) O=Occasional (3-33%) F=Frequent (34-66%) and C=Constant (67-100%) Over the years, “occasional/frequent/constant” have […]
Read more
11 Jan, 21

Lessons learned during my internship with Taylor’d Ergo

by Jessica Szarko As part of the Advanced Ergonomics Program at Fanshawe College, I completed my internship with Taylor’d Ergonomics. During the remote part of my internship I identified, described, and ‘proved’ best practices for everyday tasks, using biomechanics software. Later, I completed Physical and Cognitive Demands Analyses (PDA/CDA) for municipal employees, and I worked […]
Read more
16 Jul, 20

Beat the heat!

Summer is here, and many Canadians have flipped the switch from complaining about the cold, to complaining about the heat! After enduring long months of winter, relaxing outdoors might feel great. Unfortunately, working in that same heat can be uncomfortable and possibly even dangerous. Here are some ways to beat the summer heat while working […]
Read more
16 Oct, 19

Design, so they don’t reach for it!

If you’re familiar with ergonomics design guidelines, then you are aware of the CSA guideline (CSA Z1004-12) that provides recommended reach guidelines for “frequent”, “infrequent”, and “occasional” work. What do these guidelines represent? For reach, we usually are most concerned with a smaller worker, because a larger worker could stand further back, and achieve the […]
Read more
23 Apr, 19

A force gauge is an ergonomist’s best friend!

Force gauges are used by ergonomists to collect quantitative data for PDAs and ergonomics assessments of pushing, pulling, and lifting tasks. We often take measurements 5-6 times, to ensure we are collecting the most accurate data possible, so it’s important to have a force gauge that can “measure” up to the task. A variety of […]
Read more
Cart
X